Escape 4WD L4-2.5L Hybrid (2009)
-------------------------------------------------
R11 CHECK FOR RESTORED NETWORK COMMUNICATION WITH THE IC DISABLED
NOTE: When re-running the network test, the network test application must be first closed or the screen display will revert back to the prior run network
test results.
-
Disconnect: SJB Fuses 26 (10A), 29 (5A) and 43 (10A).
-
Enter the following diagnostic mode on the scan tool: Network Test.
-
Repeat the network test.
-
Do all other modules pass the network test?
Yes
INSTALL the removed fuses. Go To Pinpoint Test D. See: Pinpoint Test D: The Instrument Cluster (IC) Does Not Respond To The Scan Tool
No
If the vehicle is equipped with an Accessory Protocol Interface Module (APIM), INSTALL the removed fuses. GO to R12.
If the vehicle is not equipped with an APIM, INSTALL the removed fuses. GO to R13.
-------------------------------------------------
R12 CHECK FOR RESTORED NETWORK COMMUNICATION WITH THE APIM DISABLED
NOTE: When re-running the network test, the network test application must be first closed or the screen display will revert back to the prior run network
test results.
-
Disconnect: SJB Fuse 3 (15A).
-
Enter the following diagnostic mode on the scan tool: Network Test.
-
Repeat the network test.
-
Do all other modules pass the network test?
Yes
INSTALL the removed fuse. Go To Pinpoint Test P. See: Pinpoint Test P: The Accessory Protocol Interface Module (APIM) Does Not Respond To
The Scan Tool
No
GO to R13.
-------------------------------------------------
R13 CHECK FOR RESTORED NETWORK COMMUNICATION WITH THE ABS MODULE DISABLED
NOTE: When re-running the network test, the network test application must be first closed or the screen display will revert back to the prior run network
test results.
-
Disconnect: SJB Fuse 34 (5A) (Escape and Mariner) or Fuse 27 (10A) (Hybrid).
-
Enter the following diagnostic mode on the scan tool: Network Test.
-
Repeat the network test.
-
Do all other modules pass the network test?
Yes
INSTALL the removed fuse. Go To Pinpoint Test B. See: Pinpoint Test B: The ABS Module Does Not Respond To The Scan Tool
No
If the vehicle is not a Hybrid Electric Vehicle (HEV), INSTALL the removed fuse. An intermittent fault is not present. Go To Pinpoint Test S. See:
Pinpoint Test S: No High Speed Controller Area Network (HS-CAN) Communication, All Modules Are Not Responding
If the vehicle is an HEV, INSTALL the removed fuse. GO to R14.
-------------------------------------------------
R14 CHECK FOR RESTORED NETWORK COMMUNICATION WITH THE HEV TCM DISABLED
