Escape 4WD L4-2.5L Hybrid (2009)
2. Install the D-pillar trim panel.
3. Install the weatherstrip.
6. Connect the passenger side safety canopy module electrical connector.
7. Install the passenger side D-pillar trim panel.
1. Engage the D-pillar trim panel to the quarter trim panel.
2. Install the D-pillar trim panel.
3. Install the weatherstrip.
8. Connect the passenger seat side air bag module electrical connector and then slide and engage the seat side air bag electrical connector locking
clip.
9. NOTICE: During passenger air bag module installation, make sure the passenger air bag module wire harness routing clip is attached to
the passenger air bag module. Failure to follow this instruction may result in wiring harness damage.
NOTICE: The passenger air bag module electrical connectors are unique and cannot be reversed when connected to the passenger air
bag module. Match the electrical connector key to the keyway in the passenger air bag module. Do not force the electrical connectors into
the passenger air bag module. Failure to follow these instructions may result in component and/or connector damage.
Install the passenger air bag module.
1. Connect the 2 passenger air bag module electrical connectors.
2. Attach the wire harness routing clip.