Escape 4WD V6-181 3.0L DOHC VIN 1 Duratec (2003)
Rear Bumper Cover / Fascia: Service and Repair
REAR BUMPER COVER
Removal and Installation
1. If equipped, disconnect the parking aid system electrical connector.
2. Remove the six rear splash shield bolts (three each side).
3. Remove the two rear bumper cover to rear quarter panel screws (one each side).
4. Remove the four pin-type retainers.
5. Remove the rear bumper cover.
1
Remove the screws.
2
Remove the bolts and the liftgate alignment bumpers.