Escape 4WD V6-181 3.0L DOHC VIN 1 Duratec (2003)
2. CAUTION: Do not install the camshaft journal thrust caps until all of the camshaft bearing caps have been installed, or damage to the thrust caps
may occur.
Lubricate the bearing surfaces of the camshaft bearing caps with clean engine oil and install the bearing caps and loosely install the bolts.
3. Lubricate the bearing surfaces of the camshaft bearing thrust caps with clean engine oil. Install the bearing thrust caps and loosely install the bolts.
4. Tighten the bolts in the sequence shown.
5. Install the timing drive components.