Escape 4WD V6-181 3.0L DOHC VIN 1 Duratec (2003)
Using the special tool, install the crankshaft pulley.
3. NOTE: Use an appropriate strap wrench to hold the crankshaft pulley. Install the bolt and the washer and tighten in four stages.
-
Stage 1: Tighten to 120 Nm (86 ft. lbs.).
-
Stage 2: Loosen 360 degrees.
-
Stage 3: Tighten to 50 Nm (37 ft. lbs.).
-
Stage 4: Tighten an additional 90 degrees.
4. Install RH front inner splash shield.
5. Install the accessory drive belt.
