Escape 4WD V6-181 3.0L DOHC VIN 1 Duratec (2003)
Fuel Pressure Pulsation Damper: Service and Repair
REMOVAL
1. Remove the throttle body.
2. Remove the fuel pulse damper.
1
Disconnect the vacuum hose.
2
Remove the snap ring.
3
Remove the damper.
3. Remove and discard the O-ring seal.
INSTALLATION
1. To install, reverse the removal procedure.
CAUTION: Use an O-ring seal that is made of special fuel resistant material. Use of an ordinary O-ring seal can cause the fuel system to leak. Do
not reuse the O-ring seal.
NOTE: Lubricate the O-ring seal with clean engine oil.