Escape 4WD V6-181 3.0L DOHC VIN 1 Duratec (2003)
3.
Disconnect the accelerator cable as follows: See Figure 2.
A) Disconnect the cable by rotating the throttle body cam and sliding the cable barrel out of the cam.
B) Remove the accelerator cable from bracket # 1 by turning the cable housing 45 degrees either way and pulling it from the bracket.
C) Open bracket # 2 with a screwdriver and remove the accelerator cable from the bracket. See Figure 3.
D) Detach the accelerator cable from the clip located on the brake booster vacuum hose.
E) Disengage the grommet at the dash panel and remove the accelerator cable from the vehicle.
ACCELERATOR CABLE INSTALLATION
1.
Feed the new cable through the dash panel and fully seat the grommet.
2.
Install and connect the accelerator cable as follows:
A)
Connect the cable to the throttle body by rotating the cam and sliding the cable barrel into the cam.
B)
Attach the accelerator cable to the clip located on the brake booster vacuum hose.
C)
Secure the accelerator cable to bracket # 1 by inserting it and rotating the cable housing 45 degrees to lock it in place.
