Escape 4WD V6-181 3.0L DOHC VIN 1 Duratec (2003)
![background image](/ford/escape_4wd/v6-181_3.0l_dohc_vin_1_duratec/Page-441005.png)
12. Disconnect the driver safety belt buckle pretensioner electrical connector.
1
Remove the driver safety belt buckle pretensioner electrical connector from the under the seat bracket.
2
Push to release the driver safety belt buckle pretensioner electrical connector locking clip.
3
Disconnect the driver safety belt buckle pretensioner electrical connector.
13. Attach the restraint system diagnostic tool to the driver safety belt buckle pretensioner floor electrical connector.
14. Disconnect the driver side air bag module electrical connector.
1
Slide and release the driver side air bag module electrical connector locking clip.
2
Disconnect the driver side air bag module electrical connector.
15. Attach the restraint system diagnostic tool to the driver side air bag module floor electrical connector.
16. Connect the battery ground cable.
17. With the restraint system diagnostic tools installed at all deployable devices, prove out the air bag system. See: Body and Frame/Interior
Moulding / Trim/Dashboard / Instrument Panel/Air Bag(s) Arming and Disarming/Service and Repair/Prove Out Procedure