Escape 4WD V6-181 3.0L DOHC VIN 1 Duratec (2003)
5. Remove the outboard seat cushion side shield.
1
Remove the seat backrest lever cover.
2
Remove the screw.
3
Pull out to release the retaining clips and remove the seat cushion side shield.
^
If equipped, disconnect the power seat switch electrical connector.
6. Remove the inboard seat cushion side shield.
^
Pull out to release the retaining clips.
7. Release the pin-type retainers and separate the side air bag electrical connector and wire harness from the seat.
NOTE: Note the wire harness routing for installation.
8. Remove the seat backrest pivot nut.