Escape 4WD V6-181 3.0L DOHC VIN 1 Duratec (2003)
2. Remove the wheel and tire assembly.
1
If necessary, remove the center cap.
2
Remove the nuts.
3. CAUTION: Use of a brake drum puller or a torch is not recommended. Brake drum distortion can occur.
NOTE: If the brake drum is rusted to the axle shaft pilot diameter, tap the center of the brake drum between the wheel studs.
Remove the brake drum.
^
If equipped, remove the brake drum retaining clips.
4. If the brake drum will not come off, follow these steps.
1
Move the brake shoe adjusting lever off the brake adjuster screw.
2
Loosen the brake shoe adjuster screw nut by adjusting the nut upward.
5. Remove the rear halfshaft nut.