Escape 4WD V6-181 3.0L DOHC VIN 1 Duratec (2003)
![background image](/ford/escape_4wd/v6-181_3.0l_dohc_vin_1_duratec/Page-1615001.png)
Pilot Bearing: Service and Repair
Pilot Bearing
Special Tools
Special Tool(s)
Removal
1. Remove the flywheel.
2. Inspect the pilot bearing for:
^
misalignment and looseness in the crankshaft
^
needle rollers for scoring, worn or broken rollers, inadequate grease or discoloration
^
seal leakage
3. NOTE: Install a new pilot bearing only if it is damaged.
Using the special tool, remove the pilot bearing.
1
Install the special tool.
2
Remove the pilot bearing.
4. Clean the transaxle input shaft with a wire brush.
5. Inspect the transmission input shaft for:
^
burrs
^
rust
^
damage to the input shaft spline
^
damage to the input shaft on the pilot bearing contact surface
Installation