Escape 4WD V6-181 3.0L DOHC VIN 1 Duratec (2003)
6. Remove any excess air trapped in the outboard halfshaft boot using a cloth covered screwdriver after adjusting the outboard halfshaft boot spacing.
7. Using the special tool, install two new outboard halfshaft boot clamps.
8. Position the inboard halfshaft boot.
9. Install the snap ring.
10. Install the tripod joint on the halfshaft.
1
Line up the marks on the halfshaft and tripod joint.
2
Install the tripod joint on the halfshaft.
