Escape 4WD V6-181 3.0L DOHC VIN 1 Duratec (2003)
^
Install the drive gear using a slight rotation to prevent damaging the transfer case inner halfshaft seal.
2
Install the idler gear.
3
Install the driven gear.
3. CAUTION: The transfer case cover must be installed within 15 minutes of applying the silicone sealant. If the time limit is exceeded, clean the
sealing surfaces and reapply.
NOTE: Apply a 1/8-inch bead of silicone gasket and sealant to the sealing surface of the transfer case cover before installing on the transfer case.
Install the transfer case cover.
^
Install the bolts in a cross pattern.
4. Install a new dust shield.
5. Install the transfer case vent tube.
^
Install the bolts.
6. Install the transfer case.
7. Fill the transfer case.
8. Check the transaxle fluid level.