Escape 4WD V6-3.0L (2008)
Removal and Installation
CAUTION: Prior to removal of the front bumper cover, place tape at the corners of the bumper cover and below the headlamps to prevent
damage to the paint.
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Remove the 6 scrivets from inside the front splash shield (3 each side).
3. Remove the 4 fender splash shield-to-air deflector bolts (2 each side).
-
To install, tighten to 5 Nm (44 lb-in).
