Escape 4WD V6-3.0L (2008)
2. Open and remove the door handle finish panel.
-
Pull the door handle outward to fully access the door handle finish panel.
3. Remove the door handle screw.
4. Remove the door inside handle screw.
5. Remove the 3 door trim panel screws.
6. Remove the door trim panel.
-
Pull outward and then upward on the door trim panel.
-
Disconnect the electrical connectors.
7. Remove the door handle from the door trim panel.
-
Disconnect the electrical connector.
-
Press the 2 retaining tabs while pushing the door handle from the door trim panel.
-
Remove the door handle from the door trim panel by pulling it back through the door trim panel.
