Escape 4WD V6-3.0L (2008)
2. Remove the screw and the front door trim panel bracket.
3. Remove the 3 pushpins and pad assembly.
4. Position the watershield aside.
5. Connect the window control switch electrical connector.
6. Using the window control switch, lower the front door window glass to gain access to the front door window glass screws.
7. Disconnect the window control switch electrical connector.
8. Remove the 2 front door window glass screws.
-
To install, tighten to 5 Nm (44 lb-in).
9. Support the front door window glass in the full up position with tape.
10. Disconnect the front door window motor electrical connector.
11. Remove the front door window regulator and motor bolt.
-
To install, tighten to 11 Nm (8 lb-ft).
