Escape 4WD V6-3.0L (2008)
3. Enter the 5-digit permanent entry code on the keyless entry keypad.
4. Within 5 seconds of entering the code, press and hold the 3/4 button on the keypad. While holding the 3/4 button, press and release the 7/8 button
two times.
5. Release the 3/4 button. The horn will chirp once to indicate auto-unlock is disabled. If the horn chirps twice (chirp followed by a honk), the
auto-unlock feature has been enabled.
Auto-Unlock Programming Using the Message Center Procedure (If Equipped)
1. To disable/enable the auto-unlock feature, select AUTOUNLOCK [ON] OFF from the SETUP control for the current display mode.
2. Press the RESET control to turn the auto-unlock ON or OFF.
