Escape 4WD V6-3.0L (2008)
-
To install, tighten to 40 Nm (30 lb-ft).
Both rear seat backrests
15. Remove the 2 backrest latch bolts and backrest latch.
-
To install, tighten to 40 Nm (30 lb-ft).
16. Remove the RH backrest pivot bracket-to-backrest frame bolt and rear seat backrest bracket.
-
To install, tighten to 50 Nm (37 lb-ft).
17. Remove the LH backrest pivot bracket-to-backrest frame bolt and rear seat backrest bracket.
-
To install, tighten to 50 Nm (37 lb-ft).
18. To assemble, reverse the disassembly procedure.
-
Make sure the safety belts and buckles are accessible to the occupants after installation.
-
If 60 percent seat, verify the safety belt retractor operates without excessive effort or binding.
