Escape 4WD V6-3.0L (2008)
frame.
13. NOTE:
-
When installing a service part OCS, the seat wire harness pressure sensor electrical connector is not used.
-
Make sure the pressure sensor hose is not kinked during installation.
Install the OCS system components to the seat cushion pan.
1
Install the pressure sensor onto the seat cushion pan bracket, making sure the retaining tab is completely engaged.
-
When installed correctly, an audible click will be heard and the pressure sensor will not be able to be removed from its bracket without
disengaging the retaining tab.
2
Slide the OCSM into the seat cushion frame bracket.
-
The OCSM must be correctly positioned and securely fastened in place. Failure to do so can set a DTC in the RCM.
3
Install the rivets.
14. Attach the seat cushion trim cover retainers to the seat cushion frame.
15. CAUTION: While positioning the seat cushion frame and occupant classification sensor (OCS), be careful not to damage any of the
components. Failure to do so can result in component failure.
