Escape 4WD V6-3.0L (2008)
Wheel Cylinder: Overhaul
Wheel Cylinder
Material
Disassembly and Assembly
Disassembly and Assembly
WARNING: Do not use any fluid other than clean brake fluid meeting manufacturer's specification. Additionally, do not use brake fluid that
has been previously drained. Following these instructions will help prevent system contamination, brake component damage and the risk of
serious personal injury.
WARNING: Carefully read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION seek medical advice.
In the USA or Canada on Ford/Motorcraft products call: 1-800-959-3673. For additional information, consult the product Material Safety
Data Sheet (MSDS) if available. Failure to follow these instructions may result in serious personal injury.
CAUTION: Brake fluid is harmful to painted and plastic surfaces. If brake fluid is spilled onto a painted or plastic surface, immediately wash
it with water.
1. Remove the rear wheel cylinder.
2. Remove the bleeder screw cap.
3. Remove the bleeder screw.
^
To install, tighten to 5 Nm (44 lb-inch).
4. Remove the 2 dust boots.
5. Remove the 2 pistons.
6. Remove the 2 piston seals.
^
To install, lubricate the piston seals with clean brake fluid.
7. Remove the spring.
