Escape 4WD V6-3.0L (2008)
Installation
1. Lubricate the camshafts with clean engine oil and carefully position the camshafts into the cylinder head.
^
Align the camshafts as shown.
2. CAUTION: The camshaft caps must be installed in their original positions or damage to the engine may occur.
CAUTION: Do not install the camshaft bearing thrust caps until all of the camshaft bearing caps have been installed, or damage to the
thrust caps may occur.
Lubricate the bearing surfaces of the camshaft bearing caps with clean engine oil and install the bearing caps.
^
Loosely install the bolts.
3. Lubricate the bearing surfaces of the camshaft bearing thrust caps with clean engine oil and install the bearing thrust caps.
^
Loosely install the bolts.
4. Install the bolts.
^
Tighten in the sequence shown to 10 Nm (89 lb-in).
