Escape 4WD V6-3.0L (2008)
Special Tool(s)
Material
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Remove the LH and RH valve covers.
3. CAUTION: Only use hand tools when removing or installing the spark plugs or damage may occur to the cylinder head or spark plug.
Remove the 6 spark plugs.
^
To install, tighten to 15 Nm (11 lb-ft).
4. Remove the RH splash shield.
^
To install, tighten to 9 Nm (80 lb-in).
5. Rotate the crankshaft until the camshaft lobe is pointing directly away from the roller follower.
6. Using the special tool, remove the roller followers.
7. NOTE: Lubricate the camshaft followers with clean engine oil.
To install, reverse the removal procedure.
