Escape 4WD V6-3.0L (2008)
Front End Accessory Drive (FEAD) - Exploded View (Part 2)
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Remove the pin-type retainer, 5 bolts and the RH lower splash shield.
^
To install, tighten to 9 Nm (80 lb-in).
3. Using a suitable belt tensioner release tool, rotate the accessory drive belt tensioner counterclockwise and remove the accessory drive belt.
4. Remove the bolt and the accessory drive belt tensioner.
^
To install, tighten to 45 Nm (33 lb-ft).
5. NOTE: Refer to the illustration for correct drive belt routing.
To install, reverse the removal procedure.
