Escape 4WD V6-3.0L (2008)
4. Using the special tools, lift the engine 12 mm (0.47 in).
5. Remove the nut and ground wire eyelet from the engine support insulator bracket stud.
^
To install, tighten to 25 Nm (18 lb-ft).
6. Remove the 3 nuts and the engine support insulator bracket.
^
To install, tighten to 55 Nm (41 lb-ft).
7. Remove the 3 bolts and the engine support insulator.
^
To install, tighten to 48 Nm (35 lb-ft).
