Escape 4WD V6-3.0L (2008)
^
Tighten in the sequence shown to 10 Nm (89 lb-in).
2. Connect the 2 throttle body coolant hoses.
3. Attach the 2 main engine control wiring harness electrical connectors to the upper intake manifold.
4. Connect the PCV, brake booster and vacuum harness tubes to the upper intake manifold.
5. Attach the wiring retainer to the EGR vacuum regulator stud bolt and install the nut.
^
Tighten to 6 Nm (53 lb-in).
6. Connect the EGR vacuum regulator electrical connector.
7. Connect the IAC valve electrical connector and wiring harness retainer.
8. Connect the EVAP tube to the upper intake manifold.
9. Connect the vacuum harness tube fittings to the EGR valve and the EGR vacuum regulator.
10. Connect the TP sensor electrical connector and attach the wiring retainer.
11. Attach the transaxle vent tube pin-type retainer to the throttle body.
12. Install the EGR tube fitting to the EGR valve.
^
Tighten to 40 Nm (30 lb-ft).
13. Position the accelerator/speed control cables and brackets and install the 3 bolts.
^
Tighten to 10 Nm (89 lb-in).
14. Attach the speed control and accelerator cables to the throttle body.
15. Install the accelerator cable snow shield and the 2 bolts.
^
Tighten to 10 Nm (89 lb-in).
16. Install the air cleaner outlet pipe.
