Escape 4WD V6-3.0L (2008)
Part 2
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Disconnect the evaporative emission (EVAP) canister vent solenoid electrical connector.
3. Disconnect the fuel tank filler pipe vent tube from the dust separator.
4. Release the fuel vapor tube assembly-to-EVAP canister quick connect coupling.
5. Remove the 2 nuts, 3 bolts and the EVAP canister assembly.
-
To install, tighten to 7 Nm (62 lb-in).
6. To install, reverse the removal procedure.
-
Carry out the evaporative emission system leak test. See: Testing and Inspection
-
Carry out evaporative emission repair verification drive cycle.
