Escape 4WD V6-3.0L (2008)
-
Remove and discard the 12 fuel injector O-ring seals.
Installation
1. CAUTION: Use O-ring seals that are made of special fuel-resistant material. Use of ordinary O-rings can cause the fuel system to leak.
Do not reuse the O-ring seals.
NOTE: Install new fuel injector O-ring seals and lubricate them with clean engine oil.
Install the fuel injectors.
2. Position the fuel rail and install the bolts.
-
Tighten to 10 Nm (89 lb-in).
3. Attach the fuel charging wiring harness retainers to the fuel rail.
4. Connect the 6 fuel injector electrical connectors.
5. Connect the fuel rail pressure and temperature sensor vacuum tube and electrical connector.
6. Connect the fuel supply tube quick connect coupling at the fuel rail.
7. Install the upper intake manifold.
8. Connect the battery ground cable.
