Escape 4WD V6-3.0L (2008)
4. Disconnect the throttle position (TP) sensor electrical connector and detach the wiring retainer from the stud bolt.
5. Detach the transaxle vent tube pin-type retainer from the throttle body.
6. Disconnect and plug the 2 throttle body coolant hoses.
7. NOTE: Clean and inspect all sealing surfaces.
Remove the 3 bolts, the stud bolt and the throttle body.
-
Discard the gasket.
-
To install, tighten to 10 Nm (89 lb-in).
8. To install, reverse the removal procedure.
-
Install a new throttle body gasket.
