Escape 4WD V6-3.0L (2008)
clip.
9. CAUTION:
-
During passenger air bag module installation, make sure the passenger air bag module wire harness routing clip is attached to the
passenger air bag module. Failure to follow this instruction may result in wiring harness damage.
-
The passenger air bag module electrical connectors are unique and cannot be reversed when connected to the passenger air bag
module. Match the electrical connector key to the keyway in the passenger air bag module. Do not force the electrical connectors into
the passenger air bag module. Failure to follow these instructions may result in component and/or connector damage.
Install the passenger air bag module.
1
Connect the 2 passenger air bag module electrical connectors.
2
Attach the wire harness routing clip.
10. CAUTION: Do not handle the passenger air bag module by grabbing the edges of the deployment door. Failure to follow this instruction
may result in vehicle damage, equipment damage, component damage and/or system failure.
NOTE:
-
During passenger air bag module installation, make sure all the deployment door clips are fully seated into the instrument panel.
-
Use care when installing the passenger air bag module in the instrument panel (I/P). The passenger air bag module rear bracket can scratch the
front of the I/P.
Position the passenger air bag module and seat the passenger air bag module deployment door clips into the I/P.
11. Install the 2 passenger air bag module bolts.
-
To install, tighten to 8 Nm (71 lb-in).
