Escape 4WD V6-3.0L (2008)
2. Remove the headliner.
3. Detach the A-pillar tether pin-type retainer from the A-pillar.
4. NOTE: If equipped with a moonroof and/or rear window wiper assembly, note position and routing of the moonroof front drain hose and/or rear
window washer solvent hose for installation purposes.
Remove the A-pillar tether bolt.
5. Remove the 2 safety canopy module bolts located near the top of the A- and B-pillars.
6. Disconnect the safety canopy module electrical connector and detach the connector from the D-pillar.
7. Detach the safety canopy module wiring clip from the roof panel brace.
8. Remove the 2 safety canopy module bolts near the ignitor (between the C- and D-pillars).
9. If the vehicle is equipped with a moonroof, disconnect the moonroof rear drain hose.
10. If the vehicle is equipped with a rear window wiper assembly, detach the hose clip and position the hose aside.
