Escape 4WD V6-3.0L (2008)
Remove the D-ring cover by squeezing the height adjuster buttons and pulling the cover out at the bottom.
2. Remove the upper B-pillar trim panel.
3. Lower the height adjuster and remove the upper bolt.
-
To install, tighten to 48 Nm (35 lb-ft).
4. NOTE: Note the position of the lower locator tab for installation.
Raise the height adjuster and remove the lower bolt and height adjuster.
-
To install, tighten to 48 Nm (35 lb-ft).
5. To install, reverse the removal procedure.
6. Check the active restraint system for correct operation.
