Escape 4WD V6-3.0L (2008)
-
To install, tighten to 48 Nm (35 lb-ft).
4. Remove the lower B-pillar trim panel.
Passenger safety belt retractor pretensioner
5. Disconnect the safety belt tension sensor electrical connector.
All safety belt retractor pretensioners
6. Remove the safety belt anchor bolt and position aside the safety belt.
-
To install, tighten to 48 Nm (35 lb-ft).
7. Remove the safety belt retractor pretensioner bolt.
-
To install, tighten to 48 Nm (35 lb-ft).
8. Disconnect the safety belt retractor pretensioner electrical connector.
9. Unhook and remove the safety belt retractor pretensioner.
10. To install, reverse the removal procedure.
11. Repower the SRS.
12. Check the active restraint system for correct operation.
