Escape 4WD V6-3.0L (2008)
8. Unzip the backrest trim cover zipper.
9. NOTE:
-
The inboard and outboard head restraint guides are not interchangeable.
-
The head restraint guides incorporate an alignment tab that must be aligned correctly when installed.
Squeeze together the tip of each head restraint guide and pull the 4 guides out of the frame tube.
10. CAUTION: Use care when separating the seat upholstery from the hook-and-loop strip, or the hook-and-loop strip can be torn from the
seat backrest foam pad.
Separate the hook-and-loop fasteners and remove the seat backrest trim cover.
11. Remove the backrest foam pad from the backrest frame.
12. Release the seat latch cable from the retractor.
13. Remove the 2 nuts and the safety belt guide.
