Escape 4WD V6-3.0L (2008)
Clutch Master Cylinder: Service and Repair
Clutch Master Cylinder
Material
Removal and Installation
WARNING: Carefully read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION seek medical advice.
In the USA or Canada on Ford/Motorcraft products call. For additional information, consult the product Material Safety Data Sheet
(MSDS) if available. Failure to follow these instructions may result in serious personal injury.
CAUTION: Brake fluid is harmful to painted and plastic surfaces. If brake fluid is spilled onto a painted or plastic surface, wash it
immediately with cold water.
1. Disconnect the clutch master cylinder hose from the brake master cylinder.
^
Plug the brake master cylinder.
^
Plug the clutch master cylinder hose.
2. Remove the 2 clutch master cylinder nuts.
^
To install, tighten to 23 Nm (17 lb-ft).
3. Disconnect the clutch master cylinder push rod.
4. Disconnect the clutch hydraulic fluid tube fitting.
^
Plug the clutch hydraulic fluid tube.
5. Remove the clutch master cylinder.
6. To install, reverse the removal procedure.
^
Bleed the air from the system.
