Escape 4WD V6-3.0L (2008)
Installation
1. CAUTION: When inserting the gearshift cables through the dash panel, make sure the arrow on the grommet is pointing down.
Insert the gearshift cables through the dash panel.
2. Connect the selector cable.
3. Connect the shift cable.
4. Install the 2 gearshift cable grommet nuts.
^
Tighten to 10 Nm (89 lb-in).
5. CAUTION: Make sure the clips are set completely within the cable adapter groove and fully seated.
Install the 2 gearshift cable clips.