Escape 4WD V6-3.0L VIN 1 (2005)
![background image](/ford/escape_4wd/v6-3.0l_vin_1/Page-898002.png)
4. Using the special tool, remove the crankshaft pulley.
Installation
1. Lubricate the front cover and the crankshaft front seal inner lip with clean engine oil.
2. NOTE: Apply silicone gasket and sealant to the keyway in the crankshaft pulley.
NOTE: Install the crankshaft pulley within four minutes of applying silicone gasket and sealant to the Woodruff key slot.
Using the special tool, install the crankshaft pulley.
3. Install the bolt and washer. Using the special tool to hold the crankshaft pulley, tighten the bolt in four stages:
^
Stage 1: Tighten to 120 Nm (86 ft. lbs.).
^
Stage 2: Loosen one full turn.
^
Stage 3: Tighten to 50 Nm (37 ft. lbs.).
^
Stage 4: Tighten an additional 90 degrees.