Escape 4WD V6-3.0L VIN 1 (2005)
cause scratches and gouges which make leak paths.
Use a plastic scraping tool to remove all traces of sealant.
^
Clean all sealing surfaces with metal surface cleaner.
2. NOTE: The engine front cover must be installed and the bolts tightened within four minutes of applying sealant.
Apply a 6-mm (0.23-inch) diameter dot of silicone gasket and sealer to the cylinder block, lower cylinder block and cylinder head mating
surfaces.
3. NOTE: Fasteners 1, 8, 13 and 16 are stud bolts.
Position the engine front cover and install the bolts.
^
Tighten in the sequence shown to 25 Nm (18 ft. lbs.).
4. Position the power steering pump and install the bolts.
^
Tighten to 25 Nm (18 ft. lbs.).
5. Install the power steering pump pulley and the nut.
^
Tighten to 49 Nm (36 ft. lbs.).
6. Connect the CMP electrical connector.
7. Connect the CKP electrical connector.
8. Position the HO2S bracket and install the nut.
^
Tighten to 10 Nm (89 inch lbs.).
9. Install the idler pulley and the bolt.
^
Tighten to 25 Nm (18 ft. lbs.).
10. Install the accessory drive belt tensioner and the bolt.
^
To install, tighten to 45 Nm (33 ft. lbs.).
11. Install the engine support insulator.