Escape 4WD V6-3.0L VIN 1 (2005)
Tie Rod End: Service and Repair
Tie Rod End-Outer
Special Tool(s)
Removal and Installation
1. NOTE: RH side shown, LH side is similar.
With the vehicle in NEUTRAL, position it on a hoist.
2. Remove the cotter pin and the tie-rod end nut.
^
To install, tighten to 55 Nm (41 ft. lbs.).
3. Loosen the tie-rod end jam nut.
^
To install, tighten to 47 Nm (35 ft. lbs.).
4. Using the special tool, separate the outer tie-rod end from the front wheel knuckle.
5. Remove the tie-rod end.
6. To install, reverse the removal procedure.
^
Adjust the front toe.