Escape 4WD V6-3.0L VIN 1 (2005)
Removal
NOTE: If the transfer case is leaking automatic transaxle fluid, install a new transfer case driven gear seal.
1. Remove the exhaust system crossover pipe.
2. Remove the 3 bolts and the transfer case heat shield.
3. Remove the front drive axle intermediate shaft.
4. Remove the transfer case RH halfshaft dust shield.
5. Remove the transfer case RH halfshaft oil seal.
Installation
1. NOTE: Press the transfer case RH halfshaft seal until it is flush with the transfer case cover.
Using the special tools, install the RH halfshaft seal.