Removal and Installation | 14-028Installer, oil seals | | 15-051Installer, wheel hub bearing cone and oil seal | | 21-051Remover, oil seal | Blind hole bearing puller | Collet extractor 38 - 50 mm | Remove | 1. Slacken the wheel nuts, raise the vehicle and remove the rear road wheel. | | 2. Loosen the handbrake cable, (if necessary) (refer to Operation Number 12 662 0). | | 3. Remove the dust cover. | 3‐door, 4‐door, 5‐door built up to 12/1994 and Wagon built up to 07/1995 | | NOTE: The hub retaining nuts are handed, left‐hand thread on left‐hand side and right‐hand thread on right‐hand side. | 4. Remove the hub retaining nut. | Hub Assembly - Rear - Remove (15 373 0) | 5. Remove the hub and drum assembly. | Vehicles with ABS | 6. Remove the anti‐lock brake (ABS) sensor ring (refer to Operation Number 12 788 0). | All vehicles | 7. Remove the grease seal. | | 9. Using the internal extractor, remove the bearing cups. | | 10. Thoroughly clean the hub assembly. | Install | | CAUTION: The tapered self setting roller type rear bearings run in matched cups (cups and bearings must be from the same supplier). | | CAUTION: The bearings are self setting on assembly and therefore require no subsequent Service adjustment. | | NOTE: When refitting the new cups ensure that the cups fully abut their respective shoulders. | 11. Fit the new bearing cups. | NOTE: Grease the bearing before fitting. | 12. Fit the new inner bearing. | | 13. Fit a new grease seal. | Vehicles with ABS | 14. Install the ABS sensor ring (refer to Operation Number 12 788 0). | All vehicles | | NOTE: Grease the bearing before fitting. | 15. Fit the new outer bearing. | Hub Assembly - Rear - Install (15 373 0) | 16. Refit the hub and drum assembly. | | | CAUTION: Once tightened, the hub retaining nut must not be disturbed. If the torque needs to be checked the nut must be loosened by two full turns and re‐tightened. | | NOTE: Rotate the drum in the opposite direction when tightening the hub nut to prevent damage to the bearing. | 17. Install the hub retaining nut. 18. Install the dust cover. | | 19. Install the rear wheel. 20. Lower the vehicle. | | 21. Tighten the wheel nuts. 22. Adjust the handbrake (refer to Operation Number 12 662 0). | |