Escort L4-110 1.8L DOHC (1994)
7. Remove anti-rattle springs from disc pads, then the disc pads, anti-rattle shims and retaining clips. If disc pads and anti-rattle shims are to be used
again, they must be installed in their original positions.
8. If necessary, remove and resurface rotor at this time. Rotor must be machined while it is bolted to hub. Rotor and hub are mounted as an assembly
on lathe to decrease possibility of rotor runout.
INSTALLATION
1. Install disc pad retaining clips, then position anti-rattle shims on disc pads.
2. Position disc pads into caliper anchor bracket.
3. Install anti-rattle springs into disc pads.
4. Lubricate guide pin bushings with suitable brake grease.
5. Install caliper on guide pin if caliper was removed, then pivot caliper over brake disc pads.
6. Install caliper retaining bolt.
7. Perform system brake bleeding procedures.
8. Position parking brake cable into parking brake lever and bracket.
9. Adjust parking brake cable so there is no clearance between cable end and parking brake lever.
10. Tighten parking brake cable locknut.
11. Install wheel and tire assembly.