Escort L4-122 2.0L SOHC VIN P SFI (1999)
1
Align the marks on the windshield outside moulding.
2
Install the top portion of the windshield outside moulding.
3
Install the corners of the windshield outside moulding.
4
Install the sides of the windshield outside moulding from the top down.
7. Apply a bead of Urethane Adhesive to the pinch weld on top of the existing bead of urethane.
CAUTION:
^
Use only Urethane Adhesive meeting Ford specification WSB-M2G316-B to repair water and air leaks in the urethane sealant.
^
After replacing the urethane installed glass, the vehicle should not be driven until the urethane has cured. The curing time at 21°C (70°F) and
50% relative humidity is 24 hours (decreasing at higher temperatures and higher humidities). Refer to the detailed instructions provided by the
manufacturer in the kit. Inadequate curing of the urethane may adversely affect the strength of the urethane adhesive bond.
NOTE: Ensure that Urethane Metal Primer is clean and dry.
8. Use the bottom spacers and alignment marks to install the windshield glass.
CAUTION: Open the windows slightly to prevent the windshield glass from being pushed out by air pressure when a door is closed
9. After the Urethane Sealant has cured, check for water leaks and add Urethane Sealant (part of E0AZ-19562-A) where needed.
CAUTION:
^
Use only urethane adhesive meeting ford specification WSB-M2G316-B to repair water and air leaks in the urethane sealant.
^
After replacing the urethane installed glass, the vehicle should not be driven until the urethane has cured. The curing time at 21°C (70°F) and
50% relative humidity is 24 hours (decreasing at higher temperatures and higher humidities). Refer to the detailed instructions provided by the
manufacturer in the kit. Inadequate curing of the urethane may adversely affect the strength of the urethane adhesive bond.
10. Install the rear portion of the headliner.
