Excursion 2WD V10-6.8L VIN S (2001)
8. Position the quarter trim panel and push in on it securing the fasteners.
NOTE: Driver side is shown, passenger side is similar.
9. Install the third row safety belt anchor.
1
Position the safety belt anchor.
2
Using the special tool 501-010 (T77L-2100-A), install the bolt.
NOTE: Make sure the safety belt webbing is not twisted prior to installation.
10. Install the second row safety belt anchor.
1
Position the safety belt anchor.
2
Using the special tool 501-010 (T77L-2100-A), install the bolt.
NOTE: Make sure the safety belt webbing is not twisted prior to installation.
11. Install the pin-type retainers into the quarter trim panel.
NOTE: Passenger side is shown, driver side is similar.
12. Reposition the floor covering back along the rear quarter trim panel.