Excursion 2WD V10-6.8L VIN Z CNG (2003)
5. Remove the EVAP canister.
6. Remove the canister vent solenoid from the EVAP canister, if equipped.
7. Remove the EVAP canister elbow.
INSTALLATION
1. To install, reverse the removal procedure.
^
Leak test the EVAP system. See: Testing and Inspection/Component Tests and General Diagnostics/Component Tests/Evaporative Emission
System Leak Test
^
Carry out the evaporative emission repair verification drive cycle. See: Testing and Inspection/Component Tests and General
Diagnostics/Component Tests/Evaporative Emission Repair Verification Drive Cycle
NOTE: Lubricate all evaporative emission O-ring seals with MERPOL(R) O-ring Seal Lubricant or equivalent meeting Ford specification
ESE-M99B144-B.