Excursion 2WD V10-6.8L VIN Z CNG (2003)
![background image](/ford/excursion_2wd/v10-6.8l_vin_z_cng/Page-2389004.png)
2
Remove the PATS transmitter.
All Vehicles
11. Remove the key-in-ignition warning indicator switch.
12. Remove the clockspring electrical connectors and wire harness from the side of the steering column.
1
Remove the clockspring electrical connectors from the bracket.
^
Disconnect the remaining electrical connector.
2
Remove the wire harness from the retainers.
13. Remove the clockspring.
1
Release the retaining clips.
2
Remove the clockspring.
INSTALLATION
WARNING: TO REDUCE THE RISK OF SERIOUS PERSONAL INJURY, READ AND FOLLOW ALL WARNINGS, CAUTIONS AND
NOTES AT THE BEGINNING OF THE REMOVAL PROCEDURE.
Vehicles receiving a new clockspring
1. Remove the key from the clockspring, holding the rotor in its centralized position.
^
Do not allow the clockspring rotor to turn.
NOTE: A new clockspring is supplied in a centralized position and held there with a key.
Vehicles needing clockspring recentering
2. Centralize the clockspring.