Excursion 2WD V10-6.8L VIN Z CNG (2003)
CAUTION: Do not remove the shipping clip until the shoulder safety belt guide is secured in position. Allowing the safety belt to be retracted
further into the safety belt retractor may cause the safety belt retractor to lock and not release the safety belt.
Passenger side with auxiliary climate control only
3. Position the climate control duct and install the pin-type retainers.
Both sides
4. Route the second and third row safety belt anchors and guides through the B-pillar trim panel.
5. Position the quarter trim panel to the body and connect the power point electrical connector.
NOTE:
^
Do not secure the quarter trim panel as the shipping clip(s) will need to be removed from the safety belt retractor(s) later.
^
Driver side is shown, passenger side is similar.
6. Install the third row shoulder safety belt guide.
1
Position the shoulder safety belt guide.
2
Using the special tool 501-010 (T77L-2100-A), install the bolt.
3
Reposition the shoulder safety belt guide cover.
NOTE: Make sure the safety belt webbing is not twisted prior to installation.
