Excursion 2WD V10-6.8L VIN Z CNG (2003)
![background image](/ford/excursion_2wd/v10-6.8l_vin_z_cng/Page-1556005.png)
All vehicles
1. NOTE: The extension housing must have a shoulder or a boss cast into it to hold the orifice lube plug in the back of the transmission case.
NOTE: If the wrong extension housing is used, the orifice lube plug may become loose and/or fall out and cause transmission damage.
NOTE: Lightly lubricate the extension housing gasket with petroleum jelly to hold it in place during assembly.
Install the extension housing.
2. Connect the Output Shaft Speed (OSS) sensor.
3. NOTE: It will be necessary to install the rear mount and rear brace at the same time and install the bolts for the rear mount.
Install the rear transmission mount and rear brace. Install the bolts into the rear transmission mount.
4. Install the nuts for the rear transmission brace and lower the transmission onto the crossmember.