Excursion 2WD V10-6.8L VIN Z CNG (2003)
1. NOTE: Install the front driveshaft with the index marks aligned.
NOTE: An extension must be used to tighten the driveshaft to transfer case bolts. Extensions change the calibration of the torque wrench. Use the
torque wrench manual to calculate the correct settings.
NOTE: Install new bolts and retainers.
To install, reverse the removal procedure.
Driveshaft-Rear, One-Piece, 4X2
Driveshaft-Rear, One-Piece, 4x2
Removal
All vehicles
1. With the vehicle in NEUTRAL, position on a hoist.
Vehicles with slip yokes
2. CAUTION: Do not allow the output shaft to turn.
Index-mark the driveshaft and the transmission extension housing.
Vehicles with circular flange
3. Index-mark the driveshaft yoke and the transmission flange.
Vehicles with split pin yoke
4. Index-mark the driveshaft and the rear axle pinion flange.