Excursion 2WD V10-6.8L VIN Z CNG (2003)
Vehicles with circular flange
4. CAUTION: Align the index marks.
NOTE: Bolt direction is vehicle application dependent.
Position the driveshaft yoke on the transmission flange.
Vehicles with split pin flange
5. Remove the tape from the bearing cups.
6. CAUTION: Align the index marks.
Position the bearing cups in the rear axle pinion flange.
Vehicles with circular flange
7. CAUTION: Align the index marks.
Position the driveshaft yoke on the rear axle pinion flange, and loosely install the four new bolts.