Excursion 2WD V10-6.8L VIN Z CNG (2003)
![background image](/ford/excursion_2wd/v10-6.8l_vin_z_cng/Page-1711002.png)
5. Using a suitable press, remove the bearing from the driveshaft.
6. Using a suitable press, remove the dust slinger.
7. NOTE: Clean grease deposits, dirt and rust from the stub shaft.
NOTE: Inspect the stub shaft splines for nicks, gouges, or burrs. Remove with a file or emery cloth.
NOTE: The driveshaft center bearing bracket must be installed with the deep flange rearward.
To assemble, reverse the disassembly procedure.
^
Lubricate the stub shaft spline with grease.
Driveshaft Universal Joint-Single Cardan, Slip Yoke
Driveshaft Universal Joint-Single Cardan, Slip Yoke
Special Tool(s)
Disassembly
Initial disassembly